All about my cable connection for BASE

To get fixed internet from BASE, your home must be connected to the network on the street. That is what the drop cable is for. If you don't have a drop cable yet, you need to provide and install one yourself (or have it installed). The cable must be in one piece. As soon as the cable is connected to the network, you automatically and irrevocably transfer the ownership of the drop cable to the concerned network provider. 

Check below to see what you need to prepare.

The preparation

Exactly what you need to prepare depends on which network you use. If you don't know which network (Telenet or VOO) is available at your address, check first whether your address can be connected!

We cannot retrieve your data. Please make your own choice.

Telenet network

You have this

VOO netwerk

You have this

Telenet network

You have this

VOO netwerk

You have this

You will find the distribution point on the street, either on a façade or on a pole. In flats, the distribution point is sometimes in a technical room. So look for this:

Underground net

These are grey or white boxes that are often located at the property line between you and your neighbour, possibly at the kerb or even across the street.

Façade net

Runs via cables along the façade: you will find the distribution point at the first floor level or under the gutter, either on your house or your neighbour's.

Overhead net

Runs via cables on timber or concrete poles: The distribution point can be found hanging on one of those poles. No pole by your house? Be sure to look across the street.

Determine the length

The length determines which type of drop cable you need. So check the length between the distribution point and the location of your BASE installation in your home. Always measure this distance along a path that follows right angles.

Add a little extra

Always add a few extra metres to the measured length, based on the type of distribution point you have:

  • Underground net: +3 metres
  • Façade net: +2 metres
  • Overhead net: +11 metres
Determine the correct cable type

Were you successful? Then click the button below and look up the correct cable type in the table. You can buy all types of drop cable at an electrical shop.

Underground net
  • In the room where you want your BASE basic installation
  • Through the wall to the outside. 
  • In the ground directly to your property boundary. 
  • At least 60 cm deep in a conduit with a diameter of 40 mm.
  • In a sweeping curve parallel to your property
    line, to the nearest distribution point.
Façade net
  • In the room where you want your BASE basic installation.
  • Through the wall to the outside.
  • Via a hole in the façade, drilled from outside to
    inside, sloping upwards. 
  • To a point as close as possible to the nearest distribution point of the Telenet network.
Overhead net
  • In the room where you want your BASE basic installation.
  • Through the wall to the outside.
  • In the ground directly to your property boundary. 
  • At least 60 cm deep in a conduit with a diameter of 40 mm.
  • In a sweeping curve parallel to your property line, to the nearest distribution point.

Tip: Leave the remaining length of cable needed to finish the connection rolled up at the edge of your property. The technician will finish installing the drop cable and connect it to the distribution point.

Good to know

If your home is a newly built flat or a house in a newly built neighbourhood, the contractor may have already pre-installed the drop cable. Be sure to check that with the contractor.

You will find the distribution point on the street, either on a facade or on a pole. In flats, the distribution point is sometimes in a technical room. So look for this:

Underground net

These are grey or white boxes that are often located at the property line between you and your neighbour, possibly at the kerb or even across the street.

Façade net

Runs via cables along the façade: you will find the distribution point at the first floor level or under the gutter, either on your house or your neighbour's.

Overhead net

Runs via cables on timber or concrete poles: The distribution point can be found hanging on one of those poles. The cable of the distribution point goes to your house and runs along the façade. No pole by your house? Be sure to look across the street.

Overhead and underground net

Runs via cables on timber or concrete poles: The distribution point can be found hanging on one of those poles. The cable of the distribution point runs to your house and continues underground. No pole by your house? Be sure to look across the street.

Determine the length

The length determines which type of drop cable you need. So check the length between the distribution point and the location of your BASE installation in your home. Always measure this distance along a path that follows right angles.

Add a little extra

Always add a few extra metres to the measured length, based on the type of distribution point you have:

  • Underground net: +20% of total length
  • Façade net: +2 metres 
  • Overhead net: +20% of total length
Determine the correct cable type

Were you successful? Then click the button below and look up the correct cable type in the table. You can buy all types of drop cable at an electrical shop.

After choosing the correct type of drop cable and the correct length, install the cable on your own property. Depending on the distribution point, you run the drop cable for the...

Underground net
  • in the room where you want your BASE basic installation.
  • through the wall to the outside. in the ground directly to your property boundary.
  • at least 60 cm deep in a conduit with a diameter of 80 mm. 
  • in a sweeping curve parallel to your property line, to the nearest distribution point.
Façade net
  • in the room where you want your BASE basic installation.
  • through the wall to the outside.
  • via a hole in the façade, drilled from outside toinside, sloping upwards, at a height of at least 2.50 m
  • to a point as close as possible to the nearest distribution point of thenetwork.
Overhead net
  • in the room where you want your BASE basic installation
  • through the wall to the outside. 
  • via a hole in the façade, drilled from outside to inside, sloping upwards, at a height of at least 2.50 m. 
  • to a point as close as possible tothe nearest distribution point of the VOO network.
Overhead and underground net
  • in the room where you want your BASE basic installation. 
  • through the wall to the outside. 
  • in the ground directly to your property boundary. 
  • at least 60 cm deep in a conduit with a diameter of 80 mm.
  • in a sweeping curve parallel to your property line, to the nearest distribution point.
Good to know

If your home is a newly built flat or a house in a newly built neighbourhood, the contractor may have already pre-installed the drop cable. Be sure to check that with the contractor.

The drop cable has been laid. What now?

Hurray! Your drop cable is laid. You can...

For connection of your drop cable it is best to contact us at least six weeks in advance. This gives us time to prepare your cable connection properly (applying for permits, scheduling, preparing excavations, etc.).